The purpose of an amplifier is to compensate for signal loss after then antenna. If what you are proposing were true there would be no need to install an antenna in the first place. Feel free to contact customer service anytime with more questions. 2 If antenna does not pick up a signal there is nothing to amplify. Putting 2 DB8 antennas together is NOT recommended or supported by Antennas Direct. It is a smaller, high gain VHF antenna that will do better at picking up the lower VHF signals than the DB8 which covers the entire UHF band. The ClearStream5 is our newest ClearStream antenna. It may be necessary to add a C5 antenna to your setup instead of another DB8. Good question! The reason you are having an issue with the one channel in your area could be that it is a lower power VHF signal. The major downside is that it's only compatible with an Orbi mesh Wi-Fi router. Would I improve my reception significantly if I installed another DB 8 antenna right beside the existing antenna, hook them to a combiner, and then to the Pre amp? Would that be the best way to hook the two antennas together? Theoretically, would that double my signal strength? - From Joe in Fletcher, Georgia The Netgear Orbi Outdoor is a tri-band extender that performed well at over 200 feet when CNET tested it. I am getting all of the stations, except for one that comes in good most of the time. The stations that I am going after are about 60 to 65 miles away and the towers are located within a few miles of each other. An amplifier is an AC-powered device that applies electric current to your antenna coaxial cable to boost your TV signal and improve reception under certain conditions, and it functions for various antenna types. My antenna height is 35 feet with no obstructions and flat terrain. Question: I have a DB 8 antenna with a CPA 19 Pre Amp.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |